Notice Information
Notice Title
NWRT - Riparian river fencing and tree planting (Afon Wygyr, Anglesey)
Notice Description
Please email: Liam@northwalesriverstrust.org for more information.Erect ~ 765m of new fencingRemoval of any preexisting fencing.Supply and install 4 x swing gates and 2x bridleway gates.Plant a total of 637 trees.Clearing and thinning at 2x locations as indicated on the map.- Stock fencing ~ 765 m.Fence to be constructed using FSC certified, UC4 treated timber and high tensile wire. Strainer posts (~ 19) to be 7-8" diameter and at start, end and major changes in direction, supported by braced struts. Turning posts 5-6" (~ 13) used at minor changes in direction or height. Intermediate posts 3-4" diameter and no more than 11' apart.80 cm sheep netting with two strands of barbed wire, one above and one below the netting. Strainer posts and struts to be no closer than 4 m from the top of a steep bank, or if gentle sloped bank no closer than 4 m to the water's edge. The exact positioning of the fence will be agreed between the contractor, landowner, and NWRT before installation. The finished fence height should be approximately 1.1m (44").Use of a track machine is obligatory due to wet ground conditions likely to be encountered.Removal of any pre-existing fencing.- Supply and hang 4 x 12' galvanised steel access gates at the locations indicated on the plans including self-closing springs with appropriate tie-back stakes/latches. Access gates should always be hung on gate posts which are railed to a strainer, never hung on the same post that wire is tensioned to.- Supply and hang 2x wooden bridal gate with a two way opening at the locations indicated on the plans. Latches should be visible and easily operable from both sides of the gate and have an extended handle. Shutting the gate should automatically fasten the latch. Gateposts should not be used as straining posts for a fence. A minimum width of bridle gates between posts should be 1525mm. The gate should swing freely and not need a greater force than 50N to open. The gate should be at least 30mm from the adjoining post they swing past (except for any latch area) to reduce shearing action on fingers. Where physically possible, gates should be installed ideally 2000mm from any adjoining hedge or fence or at a minimum of 1000mm. Posts must be compliant with manufacturer's instructions and the hanging post must be a minimum 1100mm in the ground. Only counterweights supplied by the gate manufacturer can be used.Tree Planting. A total of 637 trees to be planted using the notch planting method. Plastic guards and wooden/bamboo canes to be used for all saplings and planted a minimum of 2m apart. As many trees as possible should be sourced of a local origin (303) https://naturalresources.wales/media/3119/choosing-provenance-in-broadleaved-trees.pdf.NOTE: To register your interest in this notice and obtain any additional information please visit the Sell2Wales Web Site at https://www.sell2wales.gov.wales/Search/Search_Switch.aspx?ID=137073. Additional SMP for the works can be obtained by emailing:Liam@northwalesriverstrust.orgAONB Wygyr tenderAONB Wygyr SMP(WA Ref:137073)
Notice Details
Publication & Lifecycle
- Open Contracting ID
- ocds-kuma6s-137073
- Publication Source
- Sell2Wales
- Latest Notice
- https://www.sell2wales.gov.wales/search/search_switch.aspx?ID=137073
- Current Stage
- Tender
- All Stages
- Tender
Procurement Classification
- Notice Type
- S2W Notice - Website Invitation to Tender Notice
- Procurement Type
- Standard
- Procurement Category
- Goods
- Procurement Method
- Open
- Procurement Method Details
- Not specified
- Tender Suitability
- Not specified
- Awardee Scale
- Not specified
Common Procurement Vocabulary (CPV)
- CPV Divisions
45 - Construction work
-
- CPV Codes
45340000 - Fencing, railing and safety equipment installation work
Notice Value(s)
- Tender Value
- Not specified
- Lots Value
- Not specified
- Awards Value
- Not specified
- Contracts Value
- Not specified
Notice Dates
- Publication Date
- 6 Dec 20232 years ago
- Submission Deadline
- 8 Jan 2024Expired
- Future Notice Date
- Not specified
- Award Date
- Not specified
- Contract Period
- Not specified - Not specified
- Recurrence
- Not specified
Notice Status
- Tender Status
- Not Specified
- Lots Status
- Not Specified
- Awards Status
- Not Specified
- Contracts Status
- Not Specified
Buyer & Supplier
Contracting Authority (Buyer)
- Main Buyer
- NORTH WALES RIVER TRUST
- Contact Name
- .
- Contact Email
- Not specified
- Contact Phone
- +44 7539128466
Buyer Location
- Locality
- LLANRWST
- Postcode
- LL26 0TY
- Post Town
- Llandudno
- Country
- Wales
-
- Major Region (ITL 1)
- TLL Wales
- Basic Region (ITL 2)
- TLL3 North Wales
- Small Region (ITL 3)
- TLL33 Conwy and Denbighshire
- Delivery Location
- Not specified
-
- Local Authority
- Conwy
- Electoral Ward
- Llanrwst a Llanddoged
- Westminster Constituency
- Bangor Aberconwy
Further Information
Notice Documents
-
https://www.sell2wales.gov.wales/Notice/Download/DocumentDownload.aspx?id=DEC459515&idx=1
6th December 2023 - Afon Wygyr Tender Doc
Open Contracting Data Standard (OCDS)
View full OCDS Record for this contracting process
The Open Contracting Data Standard (OCDS) is a framework designed to increase transparency and access to public procurement data in the public sector. It is widely used by governments and organisations worldwide to report on procurement processes and contracts.
{
"tag": [
"compiled"
],
"id": "ocds-kuma6s-137073-2023-12-06T12:37:29Z",
"date": "2023-12-06T12:37:29Z",
"ocid": "ocds-kuma6s-137073",
"initiationType": "tender",
"parties": [
{
"id": "org-60",
"name": "North Wales River Trust",
"address": {
"streetAddress": "Gwel Yr Afon, Llanddoged,,",
"locality": "Llanrwst",
"postalCode": "LL26 0TY"
},
"contactPoint": {
"name": ".",
"telephone": "+44 7539128466",
"url": "http://www.northwalesriverstrust.org"
},
"roles": [
"buyer"
]
}
],
"buyer": {
"name": "North Wales River Trust",
"id": "org-60"
},
"tender": {
"id": "ocds-kuma6s-137073-tender-137073",
"title": "NWRT - Riparian river fencing and tree planting (Afon Wygyr, Anglesey)",
"description": "Please email: Liam@northwalesriverstrust.org for more information.Erect ~ 765m of new fencingRemoval of any preexisting fencing.Supply and install 4 x swing gates and 2x bridleway gates.Plant a total of 637 trees.Clearing and thinning at 2x locations as indicated on the map.- Stock fencing ~ 765 m.Fence to be constructed using FSC certified, UC4 treated timber and high tensile wire. Strainer posts (~ 19) to be 7-8\" diameter and at start, end and major changes in direction, supported by braced struts. Turning posts 5-6\" (~ 13) used at minor changes in direction or height. Intermediate posts 3-4\" diameter and no more than 11' apart.80 cm sheep netting with two strands of barbed wire, one above and one below the netting. Strainer posts and struts to be no closer than 4 m from the top of a steep bank, or if gentle sloped bank no closer than 4 m to the water's edge. The exact positioning of the fence will be agreed between the contractor, landowner, and NWRT before installation. The finished fence height should be approximately 1.1m (44\").Use of a track machine is obligatory due to wet ground conditions likely to be encountered.Removal of any pre-existing fencing.- Supply and hang 4 x 12' galvanised steel access gates at the locations indicated on the plans including self-closing springs with appropriate tie-back stakes/latches. Access gates should always be hung on gate posts which are railed to a strainer, never hung on the same post that wire is tensioned to.- Supply and hang 2x wooden bridal gate with a two way opening at the locations indicated on the plans. Latches should be visible and easily operable from both sides of the gate and have an extended handle. Shutting the gate should automatically fasten the latch. Gateposts should not be used as straining posts for a fence. A minimum width of bridle gates between posts should be 1525mm. The gate should swing freely and not need a greater force than 50N to open. The gate should be at least 30mm from the adjoining post they swing past (except for any latch area) to reduce shearing action on fingers. Where physically possible, gates should be installed ideally 2000mm from any adjoining hedge or fence or at a minimum of 1000mm. Posts must be compliant with manufacturer's instructions and the hanging post must be a minimum 1100mm in the ground. Only counterweights supplied by the gate manufacturer can be used.Tree Planting. A total of 637 trees to be planted using the notch planting method. Plastic guards and wooden/bamboo canes to be used for all saplings and planted a minimum of 2m apart. As many trees as possible should be sourced of a local origin (303) https://naturalresources.wales/media/3119/choosing-provenance-in-broadleaved-trees.pdf.NOTE: To register your interest in this notice and obtain any additional information please visit the Sell2Wales Web Site at https://www.sell2wales.gov.wales/Search/Search_Switch.aspx?ID=137073. Additional SMP for the works can be obtained by emailing:Liam@northwalesriverstrust.orgAONB Wygyr tenderAONB Wygyr SMP(WA Ref:137073)",
"procurementMethod": "open",
"mainProcurementCategory": "goods",
"tenderPeriod": {
"endDate": "2024-01-08T12:00:00Z"
},
"eligibilityCriteria": "Previous fencing and tree planting experience required.All measurements are indicative, and quoted totals will be taken as definitive. It is the contractor's obligation to clarify measurements to their own satisfaction, as adjustment to totals after completion cannot be made. Any additional works must be approved, otherwise payment cannot be made. Any brash clearing, tree work or other ground works required to install the scheme should be determined by the contractor and included in the initial quote.It is also the responsibility of the project officer and contractor to ensure that contracted works are not carried out WITHOUT A PROJECT OFFICER PRESENT. Failure to do so will void any contracts (and H&S policies) and payment may not be made. A project officer will meet you on the day of the works at 8am to outline the details. Please let NWRT know the times and dates of all works a minimum of 72 hours before the proposed works commence. No other work than what is explicitly stated here is to be carried out unless approved by NWRT project manager. It is also the responsibility of the contractor to provide proof that all plant used are fit for purpose.",
"awardPeriod": {
"endDate": "2024-01-11T00:00:00Z"
},
"documents": [
{
"id": "ocds-kuma6s-137073-document-137073-DEC459515-1",
"title": "Afon Wygyr Tender Doc",
"url": "https://www.sell2wales.gov.wales/Notice/Download/DocumentDownload.aspx?id=DEC459515&idx=1",
"datePublished": "2023-12-06T12:37:29Z",
"dateModified": "2023-12-06T12:37:29Z",
"format": "application/pdf"
}
],
"communication": {
"atypicalToolUrl": "https://www.sell2wales.gov.wales"
},
"additionalClassifications": [
{
"id": "45340000",
"description": "Fencing, railing and safety equipment installation work",
"scheme": "CPV"
}
]
},
"noticetype": "S2W Notice - Website Invitation to Tender Notice"
}